Duct Puller DUCT PULLER TESTING

The testing schedule for the range of Trenchless Supplies Duct was carried out using the facilities and guidance of local universities, together with the large capacity tensile testing machines of industry accredited test houses. 

A comprehensive test programme was devised to ensure that a wide range of diameters as well as different wall thicknesses (SDR) and     polymer density (PE80 and PE100) were tested.

Numerous tests were performed to prove the principle of the design.   Repeatable results were gained of the classical “necking” as secondary bonding forces were overwhelmed and the polymer began to elongate.  Together with the tensile test machine read out, this was proof of the Duct Puller’s success.  

An important aspect of the testing was to ensure that the profile of the grippers was not too aggressive. In the industry it has been known for some time that incorrect geometry of the grip profile can lead to premature failure through excessive shear stress. The Trenchless Supplies Duct Puller grip profile was comprehensively tested using a series of calculated and theorised profile changes. This resulted in the ultimate  grip profile being achieved. It is this profile that has been incorporated into the range of Trenchless Supplies Duct Puller. 

The testing schedule for the range of Trenchless Supplies duct Puller was carried out using the facilities and guidance of universities, together with the large capacity tensile testing machines of industry accredited test houses.

The conclusion of the comprehensive test programme is that the range of Trenchless Supplies Duct Puller can tow P.E. pipe well in excess of the recommended towing load advised by polyethylene pipe manufacturers.

The achievements and knowledge gained during the test program, together with the analytical design process, have culminated in the production of an exceptional Standard Duct Puller.

Duct Puller STANDARD DUCT PULLER

The Standard Duct Puller is the most efficient way to allow the safe towing of polymer pipes into position. Also known as a “Towing Head” or “pipe puller” this tool is now part of pipe manufacturers’ recommended practice

IPS Size

Grip Range
inch (mm)

Picture

1"

0.925" - 1.160"
(23.5 - 29.5)

1.1/4"

1.200" - 1.500"
(30.5 - 38)

1.1/2"

1.450" - 1.750"
(36.5 - 44)

2"

1.700" - 2.150"
(43 - 54.5)

2.1/2"

2.200" - 2.600"
(55.5 - 66.5)

3"

2.550" - 3.200"
(64.5 - 81)

4"

3.275" - 4.100"
(83.5 - 104)

5"

4.170" - 5.125"
(106 - 130)

6"

5.130" - 6.08"
(130 - 154)

8"

6.450" 7.95"
(163 - 201)

The Duct Puller operates in a very similar way to an expanding bolt for anchoring into masonry.

Each Duct Puller has a series of four grippers connected to the eyebolt via a tail cone. As the eyebolt is tightened the tail is pulled toward the nose and the grippers expand. 

The Duct Puller's Key Features:-

Duct Puller Single piece high tensile steel forged eyebolt
Duct Puller Zinc coated components
Duct Puller Bullet/taper profiled nose
Duct Puller Researched gripper design
Duct Puller Rear locking nut/eyenut
Duct Puller Compatible with a range of wall thickness

 All these features culminate in making certain that Trenchless Supplies  can provide a Duct Puller that meets the demands of today’s modern contracting environment.


Home
| About Us | Products | Quality |Contacts | Site Map

Privacy Policy
| Disclaimer